Sunday, November 13, 2016

Programming the LiftMaster 374UT with the 8550 MyQ garage opener

The instructions are confusing in the 374UT manual, and I spent about 30 minutes trying to program the remote, before I figured out exactly what needs to be done.

Here are the steps:

  1. Start with your garage door closed.
  2. Put the 374UT remote into programming mode
    1. Press the bottom button until the blue LED lights up solid
      image
  3. Press the learning button in the garage door opener
    image
    1. The learn button on the garage door opener should glow solid.
  4. Press the button on the 374UT remote that you wish to program to control the garage door open.
    1. You will see the blue LED on the remote start to flash. (Dont press the button a second time just yet – this is what the manual tells you to do and messes everything up).
    2. Instead you should see the light on the garage door flash and hear 2 clicks
      image
    3. Next, the blue LED on the 374UT remote should stop flashing (may take a few seconds before this happens). When it finishes flashing, press the button you are programming a 2nd time. Again the blue LED will start flashing. Be patient, it takes about another 30 seconds. Once the programming is complete, and the programming setup was successful, the garage door will begin to open.
    4. Press any button on 374UT button quickly. This will complete the programming.

8 comments:

Unknown said...

THANK YOU

Unknown said...

THANK YOU

James Feder said...

I will be talking about Liftmaster and Craftsman garage door openers. The Chamberlain Corporation makes Craftsman, Chamberlain, and Sears Craftsman garage door openers. PasadenaGarageDoorsRepair

Unknown said...

Excellent instructions.

Unknown said...

FINALLY. Thank you!!!

in2spd said...

You are AMAZING!
I been trying to set up my 374UT remotes for several hours, watched several videos, been on phone with Liftmaster and no luck in programing remote. Gave this one last shot I search google came across this blogger and saw your post. Went to garage and tried your method in less than few minuets had both 374UT remotes programed to my Liftmaster 8550. Thank you so much.

Unknown said...

Thank you!

Unknown said...

Thank you so much!!! Was getting super frustrated. So glad I found your instructions...